Sharp SF-1120 User Manual

Page 85

Advertising
background image

<Adjustment procedure>
(1)

Make an original for adjustment.
Draw parallel lines at 10cm from the both edges of an A3 or
11"

×

17" white paper. (Be careful to draw precisely parallel

lines.)

(2)

Set the adjustment original made in (1) as shown below.

(3)

Make a normal (100%) copy on an A3 or 11"

×

17" white

paper.

(4)

Measure the distances at four points as shown below:

Adjustment procedure (1)

When La>Lb (Lc<Ld): Rotate to increase the height of the front

frame side of the No. 4/5 mirror base unit.

When La<Lb (Lc>Ld): Rotate to decrease the height of the front

frame side of the No. 4/5 mirror base unit.
Open the front cabinet, insert a screwdriver
as shown below, and turn the eccentric
screw to adjust the height of the No. 4/5
mirror base.

<Note> When turning the eccentric screw, remember how much it

is rotated from the original position. When the eccentric
screw is turned 36 degrees, the height of the front frame
side of the No. 4/5 mirror base is increased or decreased
by 2mm and the difference (La – Lb) is varied by 4mm.

If the above adjustment is not effective, then follow
the Adjustment procedure (2) .

Adjustment procedure (2)

1

Move the mirror base rail B up and down in the arrow directions
to adjust.

When La > Lb, shift the mirror base B rail upward by half of
the difference of La – Lb.

When La < Lb, shift the mirror base B rail downward by half of
the difference of La – Lb.

10mm

10mm

10mm

10mm

Parallel line

Parallel line

Blank paper

Fit the original edge with the
glass holding plate edge

Glass holding plate

Adjustment original

La

Lb

Ld

Lc

Paper
discharge
direction

No. 4/5 mirror base

Hole for screwdriver

Mirror base rail handle

Loosen

Loosen

1 scale = 1mm

7 – 11

Advertising
This manual is related to the following products: