Sanyo QXXAVC922---P - Manual (Page 68)


Chapter 7 Controlling the projector
Item Description
Contrast.....................Adjusts picture contrast
Brightness ................Adjusts picture brightness
Color ...........................Adjusts picture color saturation
Tint ..............................Adjusts picture hue
Image adjustment
This function is to adjust the projected picture image and save the image mode. To store the adjusted
value, click Store button, and to load the adjusted value, click Load button.
Item Description
Color Temp. .............. Sets a color temperature mode.
White Balance
Red, Green,
Blue ...................... Adjusts each white balance respectively.
Sharpness .................Adjusts picture sharpness.
* When the value of the white balance is changed, the color temp.
indicates "Adj."
Item Description
Gamma ........................ Adjusts brightness of darker part of the picture.
Noise reduction ....... Switches noise reduction mode
Progressive scan ......... Switches progressive mode
Reset ...........................Resets the Image adjustment to previous levels.
Store ........................... Stores the Image adjustment values. Select an item
[Image 1 - Image 4] from the pull-down menu and click
Store button.
Load ............................ Loads the Image mode. Se-
lect an image mode from the
pull-down menu and click
Load button. There may not
be available mode depend-
ing on the input mode as
shown in the table left.
Input source
Image mode Video Computer
Dynamic 4 4
Standard 4 4
Real * 4
Cinema 4 *
Blackboard(Green) 4 4
Image 1 - 4 4 4
✐ The mark "4" indicates the available image mode in the selected
input source. The error message appears when the disabled
image mode indicated with "*" is selected.