Sanyo QXXAVC922---P - Manual (Page 95)


Settings before using the Network Communication
To use the Network Communication, the capture setting of the projector must be set either [1] or [2] as
described below.
[1] Projector searches all the available subject computers in the network automatically.
or
[2] Subject computers are registered to the projector.
Perform capture setting following to the description below.
[1] When serving the capture data to all the sub-
ject computers in the network.
By using the web browser, display "Communication Setting"
from menu "Network"-"Capture"-"Page 2". Confirm that the
item Auto search subject PC is "ON". If "OFF", change mode to
"ON".
* Projector can find up to 30 computers in the network.
[] When serving the capture data to the specific
subject computers in the network.
Set the item Auto search subject PC "OFF" described in the
above and then display "Connection Setting" from menu
"Network"-"Capture"-"Page 3" with the web browser. Enter
the IP address of subject computer and click Set button to
register.
* Up to 30 computers can be registered to the projector.
✐
To display the served capture data, the software Network Capture 4 must be installed on the com-
puter.
Using the Network Communication