Sony GDM-W900 - Manual (Page 22)

4
Before using this monitor, check that the following items
are included in your package:
• Monitor (1)
• Video signal cable (1)
• Power cord (1)
• Macintosh
1) adapter (1)
• HD15 (Female) –HD15 (Male without the No. 9 pin)
adapter (1)
• Warranty card (1)
• This operating instructions (1)
This monitor will sync with any IBM or compatible system
equipped with VGA
2) or greater graphics capability.
Although this monitor will sync with other platforms, a
cable adapter is required. Please consult your dealer for
advice on which adapter is suitable for your needs.
Step 1: Connect the monitor to the
computer.
With the computer switched off, connect the video signal
cable to the monitor (HD15/5 BNC’s) and connect the other
end to the video output.
To connect the HD15 connector, use the supplied video
signal cable.
To connect the 5 BNC’s connector, use the SMF-400 video
signal cable (not supplied).
Note
Do not touch the pins of the video signal cable.
Connecting to the HD15 connector
* The HD15–HD15 adapter may be needed for some models.
Connections
to SYNC IN HD/VD to VIDEO IN R/G/B
Video signal cable SMF-
400 (not supplied)
Connecting to the 5 BNC’s connector
For the customers using IBM PC or IBM compatible
system which is not compatible with DDC2AB and
DDC2B+
This monitor uses a No. 9 pin in the video signal connector for
DDC2AB and DDC2B+ compatibility.
Some PC systems which are not compatible with either DDC2AB or
DDC2B+ may not accept the No. 9 pin. If you are not sure whether
your PC system accepts the No. 9 pin or not, use the HD15 (Female)
- HD15 (Male without the No. 9 pin) adapter (supplied). Make sure
that the male side (without the No. 9 pin) is connected to the
computer.
For the customers using the Macintosh computer
Supplied Macintosh adapter is compatible with Macintosh LC,
Performa, Quadra and Power macintosh series computers.
Macintosh II series and some older version of PowerBook models
may need an adapter with micro switches.
Step 2: Connect the power cord.
With the monitor switched off, connect the power cord to
the monitor and the other end to the power outlet.
The installation of your monitor is complete. Enjoy your
monitor.
Notice
To comply with the limits of FCC class B and IC Class B for digital
device, please attach supplied video signal cable for HD15 input or
SMF-400 (not supplied) for BNC input. Furthermore, each cable
must have ferrite cores in it.
1) Macintosh and Power Macintosh are trademarks of Apple
Computer Inc.
2) VGA is a trademark of IBM Corporation.
Connect to the computer in the same
way as for the HD15 connector.
to HD15
to video output
HD15–HD15 adapter
(supplied) *
Macintosh computer
IBM or compatible
computer
to video output
to a wall outlet
Power cord (supplied)
Macintosh adapter
(supplied)
Video signal
cable
(supplied)