Sanyo LCD-42CA9S - Manual (Page 20)

20
BASIC OPERATION
OFF TIMER
To set OFF TIMER by pressing TIMER button on Remote Control. The timer dialogue box will appear on the
screen for a short while.
To select "0 min", "30 min", "60 min", "90 min" or "120 min" with TIMER buttons.
Press PIP button to display sub picture.
During PIP mode, pressing the MAIN/SUB button will switch main and sub picture.
The sound on the main picture and the sub-picture also changes at the same time.
Each time PIP button is pressed, the location of sub picture is changed as follows.
Press PIP button or POWER ON/OFF button to exit PIP mode.
PIP OPERATION
Using PIP function, you can enjoy a TV program and an image such as DVD input from a rear terminal at
the same time.
Press CHANGE button in PIP mode can switch input source in Sub picture. (Refer to this page "PIP
Combination".
The following combination (Main and Sub picture) in the PIP mode, " " indicates that it is possible for combination,
and "X" indications that it is impossible for combination.
Note: DVD input terminal should be connected so that AV2-DVD in the following table can be combined with TV or AV1-S,
otherwise it cannot be combined with TV or AV1-S.
Combination of the Main-picture and Sub-picture
PC
MAIN
X
SUB
HDMI 2 HDMI 1 TV AV1-S AV2-DVD
PC
HDMI 2
HDMI 1
TV
AV1-S
AV2-DVD
X
X
X
X
X
X
X
X
X
Note: The controls belongs to the picture which is TV input in PIP mode. Otherwise, it belongs to the main
picture.
Main Picture Sub Picture
2
1
3
4
5
LCD-CA9S-A NEW.indd 20 2/06/2008 2:08:18 PM