Philips 10002519 - Manual (Page 25)

2
STEAM EJEcTION - clEANING ANd MAINTENANcE
spout (pannarello) (12) and open the “hot water/
steam” knob (14) for a few seconds so as to let
the remaining water come out of the steam spout
(pannarello). In a short time, only steam will come
out of the spout.
• close the knob (14).
• Fill 1/3 of the container you wish to use to prepare
the cappuccino with cold milk.
use cold milk and a cold cup for better
results when preparing a cappuccino.
• (Fig. 30) - Immerse the steam spout (pannarello)
in the milk to be heated and open the knob (14).
Move the container gently up and down to level the
foam formation.
• After using the steam for the desired time, close
the knob (14).
• The same system may be used to heat other
beverages.
After using the steam spout (pannarello), clean it
as described in the “cleaning and Maintenance"
section.
9.1 Steam/coffee switchover
• Press the button (20) to brew coffee.
• during the switchover from steam to coffee brewing,
the lights (19) and (21) flash simultaneously
showing the machine’s overtemperature. coffee
may not be brewed.
• discharge water to brew coffee. Place a container
beneath the steam spout (pannarello) (12). Turn
the steam knob (14) counterclockwise and wait
until only the green temperature ready light (19) is
permanently on. Then close the knob by turning it
clockwise.
10 CleaninG anD mainTenanCe
General cleaning
• Maintenance and cleaning operations may only be
carried out when the machine has cooled down and
has been disconnected from the power supply.
• do not immerse the machine in water or place any
of its parts in a dishwasher.
• do not use sharp objects or harsh chemical
products (solvents) for cleaning.
• clean the pannarello after every use. Remove the
external part of the pannarello.
Wash the external part of the pannarello under
running water.
• For a thorough cleaning, remove the pannarello
from the steam spout.
loosen the ring nut and remove the internal part
of the pannarello. After washing it thoroughly,
reassemble it taking care to position it as shown
in the figure.
(Fig. 25) - clean the water tank on a daily basis.
- Remove the filter in the water tank and wash it
under drinking running water.
- Reinsert the filter into its seat by gently pressing
and turning it.
- Fill the tank with fresh drinking water.