Sharp AR-156 - Manual (Page 17)

15
2
Making copies
NORMAL COPYING
D. When copying in the two-sided to one-sided mode:
Use the original to copy key to select the two-sided to one-sided copying mode.
The originals must have been set in the RSPF in step 3.
Ensure that the desired paper tray is selected.
● Paper sizes that can be used in the duplex copy mode are letter, legal, and
invoice. (When copying from the original table in the duplex copy mode, only
letter size paper can be used.)
● The bypass tray cannot be used in the duplex copy mode.
Set the number of copies using the two copy quantity ( , ) keys when copying
from the original table or copying in a 1-sided copy mode from the RSPF.
● Press the clear ( ) key to clear an entry if a mistake is made.
● A single copy can be made with the initial setting, i.e., when “0” is displayed.
● Press the right copy quantity key to set the units
digit from 0 to 9. This key will not change the tens
digit.
● Press the left copy quantity key to set the tens
digit from 1 to 9.
Press the print ( ) key.
● To display the number of copies made in a continuous run, press the left copy
quantity key.
● To stop copying in the middle of a run, press the clear ( ) key. Copying will
stop and the number in the display will be reset to “0”.
Tens digit Units digit
A B C D