Sony PFV-L10 - Manual (Page 16)

1-10 (E)
PFV-L10
1-11. Function of STATUS OUT Connector
1-12. Unleaded Solder
8 1
15 9
1-11. Function of STATUS OUT Connector
The PFV-L10 output the following status with the STATUS OUT connector.
<External view>
Pin No. Signal Location Status
L H
1 DIAG 1 SLOT 1 Normal operation or No board Board: Error
2 DIAG 2 SLOT 2 Normal operation or No board Board: Error
3 DIAG 3 SLOT 3 Normal operation or No board Board: Error
4 DIAG 4 SLOT 4 Normal operation or No board Board: Error
5 DIAG 5 SLOT 5 Normal operation or No board Board: Error
6 DIAG 6 SLOT 6 Normal operation or No board Board: Error
7 DIAG 7 SLOT 7 Normal operation or No board Board: Error
8 DIAG 8 SLOT 8 Normal operation or No board Board: Error
9 DIAG 9 SLOT 9 Normal operation or No board Board: Error
10 DIAG PS B POWER B Normal operation Power : OFF or
Temperature : Too high
11 DIAG PS A POWER A Normal operation Power : OFF or
Temperature : Too high
12 FAN STOP FAN Normal operation Stop
13 OVER LOAD POWER A, B Normal operation Load current: 13 A or more
(Load current: less than 13 A)
14 DIAG 10 SLOT 10 Normal operation or No board Board: Error
15 GND _ _ _
1-12. Unleaded Solder
Boards requiring use of unleaded solder are printed with a
lead free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come
printed with the lead free mark due to their particular size.)
: LEAD FREE MARK
m
. Be sure to use the unleaded solder for the printed circuit
board printed with the lead free mark.
. The unleaded solder melts at a temperature about 40 dC
higher than the ordinary solder, therefore, it is recom-
mended to use the soldering iron having a temperature
regulator.
. The ordinary soldering iron can be used but the iron tip
has to be applied to the solder joint for a slightly longer
time. The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful.