Sony CDP-XE320 - Manual (Page 4)

Getting Started
4 GB
Unpacking
Check that you received the following items:
• Audio connecting cord (1)
• Remote commander (remote) (CDP-XE520 and
CDP-XE320 only) (1)
• Sony SUM-3 (NS) batteries (CDP-XE520 and
CDP-XE320 only) (2)
Inserting batteries into the remote
(CDP-XE520 and CDP-XE320 only)
You can control the player using the supplied remote.
Insert two size AA (R6) batteries by matching the +
and – on the batteries. When using the remote, point it
at the remote sensor g on the player.
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
White
(L)
Red
(R)
White
(L)
Red
(R)
What cords will I need?
Audio cord (supplied) (1)
Hookups
When connecting an audio cord, be sure to match the
colour-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Amplifier CD player
INPUT
CD
L
R
L
LINE
OUT
R
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
CD player
Audio input
(L)
: Signal flow
Amplifier
To mains
To mains
Audio input
(R)
LINE OUT
(R)
LINE OUT
(L)