Sony Ericsson BDV-E300 - Manual (Page 31)

31 GB
Ge
tting Star
te
d
Step 3: Performing the
Easy Setup
Follow the Steps below to make the basic
adjustments for using the system.
Displayed items vary depending on the country
model.
1
Turn on the TV.
2
Press [/1 on the unit.
3
Switch the input selector on your TV so
that the signal from the system
appears on the TV screen.
The Easy Setup Display for OSD language
selection appears.
If the Easy Setup Display does not
appear
Recall the Easy Setup Display. See “To
recall the Easy Setup Display” (page 34).
4
Press X/x to select a language for the
OSD.
5
Press or c.
The setting message appears.
This message appears only when
performing the [Easy Setup] for the first
time. It does not appear when performing
the [Easy Setup] accessed via the [Setup]
setting.
6
Press or c.
The Setup Display for video cable selection
appears.
7
Press X/x to select the cable used to
connect the unit and TV.
Check the connection of the unit and TV
(page 22).
• When you connect the unit and TV with
an HDMI cable, select [HDMI], go to
Step 8 and set the video output resolution
to match your TV.
• When you connect the unit and TV with a
component video cord, select
[Component Video], go to Step 8 and set
the video output resolution to match your
TV.
• When you connect the unit and TV with
the video cord, select [Video] and go to
Step 9.
3 2 1
6 5 4
9 8 7
0
C/X/x/c,
HOME
"/1
English
Deutsch
Français
Italiano
Español
Select the language to be displayed by this unit.
Easy Setup - OSD
Easy Setup
Each of these items may be changed later under "Setup."
Set the items below required to use this unit.
Start
- Select the BD Internet Connection
- Select the TV connection method
- Select the TV type
- Select the Standby Mode
Check that all cables, etc. have been connected and then start.
- Execute the Auto Calibration
Easy Setup - TV Connection Method
Component Video
Video
Select the video cable connecting this unit and the TV.