Woodstock SHOP FOX M1099 - Manual (Page 15)

-13-
Df[\cD('00 D]^J`eZ\('&'.
J<
K
LG
K\jkIle 9i\Xb$@e
The purpose of the test run is to make sure the lathe and
safety features operate correctly before proceeding with
additional setup.
KfY\^`ek_\k\jkile Yi\Xb$`egifZ\[li\#[fk_\j\
jk\gj1
(% Make sure the lathe is lubricated and the headstock
oil level is full. Refer to >\e\iXcClYi`ZXk`fe on
GX^\*).
)% Make sure the chuck is correctly secured to the spin-
dle. Refer to Dflek`e^:_lZbXe[=XZ\gcXk\ on GX^\
(- for details.
*% Change the belt position so the spindle will rotate at
150 RPM, and disengage the half nut with the lever
shown in
=`^li\*. Refer to ;\k\id`e`e^:fii\Zk
Jg`e[c\IGD on GX^\).for clarification.
+% Rotate the red emergency stop button (=`^li\+)
clockwise so it pops out, and make sure the motor
direction selector points to STOP.
,% Move the numeric gearbox dial to ;, and the alpha
gearbox dial to 5 (see =`^li\+).
Efk\1 PfldXp_Xm\kfjc`^_kcpifkXk\k_\Z_lZbYp
_Xe[kf\e^X^\k_\^\Xij%
-% Push the green power button, then turn the motor
direction dial to FWD. The top of the chuck should
now be turning toward you.
.% Push the emergency stop button. The lathe
should stop. If not, disconnect power and refer to
KiflYc\j_ffk`e^ on GX^\*,.
/% Return the motor direction dial to STOP, reset the
emergency stop button, restart the lathe, and let
the lathe run for a minimum of 10 minutes.
— If you hear squealing or grinding noises, turn the
lathe F== immediately and correct any problem
before further operation.
— If the problem is not readily apparent, refer to
KiflYc\j_ffk`e^ on GX^\*,.
DXb\ jli\ k_\ _Xc] elk c\m\i `j
[`j\e^X^\[Y\]fi\pfljkXikk_\cXk_\
K_fifl^_cp]Xd`c`Xi`q\pflij\c]n`k_Xcc
k_\ZfekifcjXe[k_\`i]leZk`fejY\]fi\
lj`e^ k_\ cfe^`kl[`eXc ]\\[ E<M<I
J?@=KC8K?<><8IJN?<ED8:?@E<@J
FG<I8K@E>%
=`^li\*% Half nut lever in the disengaged
position.
Half-Nut Lever Pulled Up
(Disengaged)
=`^li\+% Headstock and gearbox controls.
Emergency Stop Button
Motor Direction Selector
Pointing to STOP
Numeric
Dial
Alpha
Dial