Woodstock SHOP FOX M1099 - Manual (Page 36)

-34-
Df[\cD('00 D]^J`eZ\('&'.
J<I
M
@:<
9\ck8[aljkd\ekfi
I\gcXZ\d\ek
8
:
=`^li\+(% High-range belt position (A-C).
Kfi\gcXZ\fiX[aljkk_\M$Y\ckj#[fk_\j\jk\gj1
(% DISCONNECT POWER TO THE LATHE!
)% Open the side access door to expose the belt, pul-
leys, and change gears.
— If the high range belt ( =`^li\+() needs to be
replaced, carefully roll the belt off of pulleys 8
and : and reinstall the new one.
— If the low range belt ( =`^li\+)) needs to be
replaced, use the 17mm wrench to loosen the
tensioner pulley arm that holds the pulley and
replace the belt on pulleys
9 and :% Hold the ten-
sioner pulley against the new belt so the belt is
tight, and tighten the tensioner pulley in place.
<EK8E>C<D<EK?8Q8I;
;`jZfee\Zkk_`jcXk_\]ifdgfn\i
Xe[nX`klek`cXccjg`ee`e^gXikj
_Xm\ Zfd\ kf X Zfdgc\k\ jkfg
Y\]fi\ pfl XZZ\jj k_\ Y\ck Xe[
glcc\pj% Fk_\in`j\ pfl dXp Y\
j\m\i\cp`eali\[
9
:
Tensioner Pulley
=`^li\+)% Low-range belt position (B-C).