Woodstock SHOP FOX M1099 - Manual (Page 32)

-30-
Df[\cD('00 D]^J`eZ\('&'.
FG
<
I
8
K@FEJ
@eZ_K_i\X[j
=`^li\*+% Inch threading setup.
4-+KG@
Y
Inch
Thread
Chart
X
Use these steps to learn how to setup your lathe for inch
threading. The example in
=`^li\*+ shows lathe setup
for cutting 64 TPI (Teeth Per/Inch) thread.
Kfj\klg]fi`eZ_k_i\X[`e^#[fk_\j\jk\gj1
(% DISCONNECT THE LATHE FROM POWER!
)% Turn the feed dials to the numeral and letter indi-
cated by the chart in =`^li\*+.
*% Using the chart in=`^li\*+, gather the required
change gears.
+% Open the side cover and use a 6mm hex wrench to
loosen the lash adjuster ( =`^li\*)) and swing the
change gear assembly out of the way.
,% Remove the spindle E-clips and cap screw, lubricate,
and swap out the change gears in the order shown
on the chart in
=`^li\*)%
-% Move the lash adjuster so the gear backlash is
between 0.003" to 0.008", tighten the lash adjuster
cap screw, and close the side cover.
.% Using a 5mm hex wrench, make sure the carriage
lock is loose ( =`^li\*().
=`^li\**% Thread dial chart and
thread dial.
;li`e^ k_i\X[`e^ b\\g pfli _Xe[ fe
k_\ _Xc]$elk c\m\i i\X[p kf [`j\e^X^\
k_\_Xc]elkkfXmf`[gfk\ek`XcZXii`X^\&
Z_lZbZiXj_%
/% The lathe is now setup for threading.
 Efk\1 =fi]Xjk\ik_i\X[`e^Xe[dXelXc
ZXii`X^\i\klie#YXj\[fen_`Z_KG@
Y\`e^Zlk#i\]\ikfk_\@e[`ZXkfiKXYc\
`e =`^li\**kfbefn`]pflZXelj\
k_\k_i\X[[`XcjZXc\kfj_fnn_\ekf
i\$\ek\ik_\k_i\X[dXelXccpX]k\i[`j$
\e^X^`e^k_\_Xc]elkc\m\i%