Woodstock SHOP FOX M1099 - Manual (Page 25)

-23-
Df[\cD('00 D]^J`eZ\('&'.
FG
<
I
8
K@FEJ
:\ek\ij
A dead center can be used in the tailstock and lathe
spindle to support workpieces. When used in this man-
ner, make sure to keep the dead center tip and workpiece
lubricated to prevent tip galling.
Kf`ejkXccX[\X[fic`m\Z\ek\i#[fk_\j\jk\gj1
(% Feed the quill out about 1" and insert the dead cen-
ter ( =`^li\)(). The mating tapers provide the lock-
ing fit.
)% Move the tailstock into position and lock in place.
Efk\1DXb\jli\k_\i\`jXZ\ek\i[i`cc\[_fc\`ek_\
\e[f]k_\nfibg`\Z\]fik_\[\X[Z\ek\i%
*% Feed the quill into the workpiece. 
+% Lock the quill into place once the dead center and
the workpiece rotate together. The quill may need to
be adjusted during operation.
,% To remove the dead center, retract the quill until
the dead center pops free.
Kf`ejkXccXeDK+[\X[Z\ek\i`ek_\jg`e[c\#[fk_\j\
jk\gj1
(% DISCONNECT POWER TO THE LATHE!
)% Remove the chuck from the spindle.
*% Install the MT#4 dead center in the spindle.
+% Attach the faceplate to the spindle, see =`^li\ )).
Refer to Dflek`e^:_lZbXe[=XZ\gcXk\ on GX^\(-
for details if required.
Efk\1 N_\elj`e^k_\[\X[Z\ek\i`ek_\jg`e[c\#
lj\XcXk_\[f^jfk_XkpfligXikn`ccifkXk\n`k_
k_\]XZ\gcXk\Xe[efkjg`efek_\[\X[Z\ek\ik`g%
=`^li\))% Faceplate and dead center
setup.
=`^li\)(% Inserted dead center.
=X`cli\kfb\\g[\X[Z\ek\igf`ekn\cc
clYi`ZXk\[n`cc^Xcck_\[\X[Z\ek\iXe[
nfibg`\Z\%