SMC Networks Barricade SMC7004VWBR V.2 - Manual (Page 14)

Installing the Wireless Barricade Router
10
3. Power on: Connect the power adapter to the Wireless
Barricade.
Figure 2. Connecting the Wireless Barricade Router
Attach to Your Network Using Ethernet Cabling
The four LAN ports on the Wireless Barricade auto-negotiate the
connection speed to 10 Mbps Ethernet or 100 Mbps Fast
Ethernet, and the transmission mode to half duplex or full duplex.
Use twisted-pair cable to connect any of the four LAN ports on
the Wireless Barricade to an Ethernet adapter on your PC.
Otherwise, you can cascade any of the LAN ports on the
Wireless Barricade to an Ethernet hub or switch, and then
connect your PC or other network equipment to the hub or
switch. When inserting an RJ-45 plug, be sure the tab on the plug
clicks into position to ensure that it is properly seated.
Warning: Do not plug a phone jack connector into any RJ-45
port. This may damage the Wireless Barricade.
Instead, use only twisted-pair cables with RJ-45
connectors that conform with FCC standards.
Internet
Access
Device
Wireless
Router
Cable/DSL
Broadband
SOHO Office or Residence
SMC7004A WBR
LAN 1 PWR WLA N W AN 2 3 Link Activ ity
Notebook with
Wireless PC Card
Internet