Strahl D1600mkII - Manual (Page 157)

149
Inser
t FX (2in2out x 2) /
Master FX / Final FX
Inser
t FX (2in2out x 2) /
Final FX
Inser
t FX
(1in2out x 2)
Inser
t FX
(1in1out x 4)
Inser
t FX
(1in1out x 8)
Ef
fect Control
Ef
fect Parameter List
Effects within multi-effect programs
MM1–MM33, and their parameters
Here are explanations of the parameters of each effect in the
multi-effect chains listed above.
P4EQ (Parametric 4band EQ)
Excit1 (Exciter1)
Excit2 (Exciter2)
This adds Pre LEQ and Pre HEQ to Exciter 1.
Wah (Wah/Auto Wah)
:Mode
Select “Pedal” if you wish to use an expression pedal to control the
wah.
Comp1 (Compressor1)
Comp2 (Compressor2)
This effect adds Pre LEQ and Pre HEQ to Comp1.
Lmtr (Limiter)
AmpSim (Amp Simulator)
MicSim (Mic Simulator)
Refer to p.147.
Decima (Decimator)
ODHiG (OverDrive/HighGain)
ChFl1 (Chorus/Flanger1)
ChFl2 (Chorus/Flanger2)
Fc1 (Band1 Cutoff [Hz])................20Hz...1.0k Sets the center frequency of Band 1
Q1 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 1
G1 (Gain [dB]) .................................–18...+18 Sets the gain of Band 1
Fc2 (Band2 Cutoff [Hz])................50Hz...5.0k Sets the center frequency of Band 2
Q2 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 2
G2 (Gain [dB]) .................................–18...+18 Sets the gain of Band 2
Fc3 (Band3 Cutoff [Hz])............300Hz...10.0k Sets the center frequency of Band 3
Q3 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 3
G3 (Gain [dB]) .................................–18...+18 Sets the gain of Band 3
Fc4 (Band4 Cutoff [Hz])............500Hz...20.0k Sets the center frequency of Band 4
Q4 (Q) .............................................0.5...10.0 Sets the bandwidth of Band 4
Gain4 (Gain [dB]) ............................–18...+18 Sets the gain of Band 4
Trim (Trim) ...........................................0...100 Sets the parametric EQ input level
Blend (Exciter Blend)...................–100...+100 Sets the intensity (depth) of the Exciter
effect
Empha (Emphatic Point)......................0...140 Sets the frequency range to be empha-
sized
Blend (Exciter Blend)...................–100...+100 Sets the intensity (depth) of the Exciter
effect
Empha (Emphatic Point)......................0...140 Sets the frequency range to be empha-
sized
Trim (EQ Trim) .....................................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) .............–15...+15 Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]) ............–15...+15 Sets the gain of High EQ
FcBtm (Frequency Bottom) .................0...100 Sets the lower limit of the wah center fre-
quency
FcTop (Frequency Top)........................0...100 Sets the upper limit of the wah center
frequency
*Mode (Sweep Mode) ...........Auto, Pedal, LFO Selects the control from auto-wah, mod-
ulation source, and LFO
*Speed (LFO Frequency [Hz]).........0.02...20.0 Sets the LFO speed
Reso (Resonance) ..............................0...100 Sets the resonance amount
LPF (LPF)........................................... Off, On Switches the wah low pass filter on and
off
Sense (Sensitivity)...............................1...100 Sets the sensitivity
Attack (Attack) .....................................1...100 Sets the attack level
Level (Output Level) ............................0...100 Sets the output level of the compressor
Sense (Sensitivity)...............................1...100 Sets the sensitivity
Attack (Attack) .....................................1...100 Sets the attack level
Trim (EQ Trim) .....................................0...100 Sets the EQ input level
LEQG (Pre HEQ Gain [dB]).............–15...+15 Sets the gain of High EQ
HEQG (Pre LEQ Gain [dB]) ............ –15...+15 Sets the gain of Low EQ
Level (Output Level) ............................ 0...100 Sets the output level of the compressor
Ratio (Ratio) ..................... 1.0:1...50.0:1, Inf:1 Sets the signal compression ratio
Thrshl (Threshold [dB]) ....................... –40...0 Sets the level above which the compres-
sor is applied
Attck (Attack)....................................... 1...100 Sets the attack time
Relse (Release) .................................. 1...100 Sets the release time
GLevel (Gain Adjust [dB])........ –Inf, –38...+24 Sets the limiter output gain
Type (Amplifier Type)............... SS, EL84, 6L6 Selects the type of guitar amplifier
LPF (Pre LPF) .....................................Off, On Selects whether the harmonic noise
caused by a decrease in sampling fre-
quency is generated
Fs (Sampling Frequency [Hz]) .... 1.0k...44.1k Sets the sampling frequency
Bit (Resolution)...................................... 4...24 Sets the data bit length
HiDamp (High Damp [%]).................... 0...100 Sets the ratio at which the high range is
cut
Level (Output Level) ............................ 0...100 Sets the decimator output level
Mode (Drive Mode)
......................... OD(Overdrive), HiG(Hi-Gain)
Switching between overdrive and hyper-
gain mode
*Drive (Drive) ........................................ 1...100 Sets the degree of distortion
Level (Output Level) .............................. 0...50 Sets the overdrive output level
LoFc (Low Cutoff [Hz]) .................20Hz...1.0k Sets the center frequency for Low EQ
(shelving type)
LoG (Gain [dB]) ............................... –18...+18 Sets the gain of Low EQ
Md1Fc (Mid1 Cutoff [Hz])
.................................................300Hz...10.0k
Sets the center frequency for Mid/High
EQ 1 (peaking type)
Md1Q (Q) ........................................ 0.5...10.0 Sets the band width of Mid/High EQ 1
Md1G (Gain [dB]) ............................ –18...+18 Sets the gain of Mid/High EQ 1
Md2Fc (Mid2 Cutoff [Hz])
.................................................500Hz...20.0k
Sets the center frequency for Mid/High
EQ 2 (peaking type)
Md2Q (Q) ........................................ 0.5...10.0 Sets the band width of Mid/High EQ 2
Md2G (Gain [dB]) ............................ –18...+18 Sets the gain of Mid/High EQ 2
DTime (Delay Time [msec])............. 0.0...50.0 Sets the delay time
LFO (LFO Waveform)....................... TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz]) ................ 0.02...20.0 Sets the LFO speed
*Depth (Depth)...................................... 0...100 Sets the depth of LFO modulation
Fdback (Feedback) ..................... –100...+100 Sets the feedback amount
Mix (Wet/Dry) .................... –Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
DTime (Delay Time [msec])............. 0.0...50.0 Sets the delay time
LFO (LFO Waveform)....................... TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz]) ................ 0.02...20.0 Sets the LFO speed
*Depth (Depth)...................................... 0...100 Sets the depth of LFO modulation
Fdback (Feedback) ..................... –100...+100 Sets the feedback amount
EQTrim (EQ Trim)................................ 0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) ............. –15...+15 Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB])............ –15...+15 Sets the gain of High EQ
Mix (Wet/Dry) .................... –Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
Inser
t FX
(1in1out x 4)