Sanyo DP32746 - Manual (Page 12)

12 Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
DIGITAL AV CONNECTIONS
■
Press the INPUT key after connecting cables to access the
AV Inputs. There is NO need to tune to a blank channel.
■
With a DVI connection, make sure you connect Audio out to
the DTV’s VIDEO3 Audio in.
■
Because the VIDEO3 audio jacks are used to receive the
audio from the DVI device, these video jacks cannot be used
when a DVI device is connected.
1 Switch off DT V and external equipment
before connecting cable.
(Cable is not
supplied.)
2 Connect the STB’s DVI Output to a “DVI to
HDMI Cable;” then connect the cable to
the DTV’s HDMI input.
NOTE: Check with your local electronics
store for a DVI to HDMI Cable that
matches your equipment and the
DTV.
3 Connect the STB’s Audio L / R to the DTV’s
VIDEO3 Audio L / R.
4 The DTV must be turned on first, press
POWER. Then turn on your external
equipment.
5 Press INPUT to select HDMI to view a
digital program.
BACK VIEW
OF DTV
2 3
SET-TOP BOX (Can be a Digital
Satellite Receiver, DVD Player, or
similar digital device.) What you will need for
connections:
DVI to HDMI Cable – 1
Audio Cable – 1
REMOTE CONTROL
5
4
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must
run All Channel Search twice before you can
select the AV inputs.
CONNECTING STB WITH DVI OUTPUT TO HDMI INPUT