Care and cleaning, Cleaning the cabinet – Sanyo DP32746 User Manual
Page 29
Problem
Check these Conditions
Try these Solutions
Page No.
No DTV Stereo or
SAP sound.
●
Check if station is broadcasting a true
MTS stereo signal or a SAP signal.
●
Press AUDIO key.
18
No UHF, VHF
Channels OK.
●
Cable Channel indicator C should not
appear next to the channel number.
●
Switch Analog antenna signal to
VHF/UHF.
22
Cannot select or
scan some
channels.
●
Channel may be removed from
memory.
●
Check antenna connections.
●
No digital signal being broadcast.
●
Signals are weak.
●
V-Guide is set to block programming.
●
Select Channel Scan Memory and manu-
ally add channels or start CH. (channel)
search.
●
Turn Antenna or install signal booster.
●
Set V-Guide to “None” or press the
RESET key to clear all settings and
restart channel search.
23
25 ~ 26
19
No Cable channels
above number 13.
●
Cable Channel Indicator C should
appear next to channel number.
●
Switch Analog Antenna signal to Cable.
22
Remote Control
will not work DTV.
●
Check batteries
●
Make sure DTV is plugged in.
●
Replace batteries two “AAA.”
●
Aim remote control at front of DTV.
6,17~19
Cabinet makes
popping sound.
●
This is a normal condition during
warm-up and cool down of the plastic
cabinet parts.
29
Need help?
Visit our Web site at
www.sanyoctv.com
or Call
1-800-877-5032
This symbol on the nameplate means the product is Listed by Underwriters’
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
CARE AND CLEANING
CLEANING THE CABINET
The surface of the cabinet can be damaged if not
properly maintained. Many common household
aerosol sprays, cleaning agents, solvents, and
polishes will cause permanent damage to the
fine surface.
1. Unplug the power cord before cleaning the
television.
2.. Gently wipe the screen and cabinet with a
DRY SOFT CLOTH.
The screen is likely to be damaged if it is not
maintained properly. DO NOT use hard objects
such as hard cloth or paper. DO NOT use
excessive pressure when cleaning the LCD
screen; excessive pressure can cause perma-
nent discoloration or dark spots.
NOTE: Never spray liquids on
the screen because they can
run down and enter the
cabinet. This may cause com-
ponent failure not covered
under Warranty.