Sony D-368 - Manual (Page 3)

D-368.3-859-215-1X.U2
To resume playing from the point
you stopped the CD (Resume Play)
Normally, every time you stop and play,
playing starts from the beginning of the CD.
The resume play function, however, let you
listen to from the point at which you last
turned off the Discman.
Set RESUME to ON.
To cancel resume play, set RESUME to OFF.
Notes
• Even if RESUME is set to ON, playing starts
from the beginning when you open the lid.
• The resume point may be inaccurate by about
30 seconds.
To turn off the beep
You can turn off the beep that sounds as you
operate your Discman.
Disconnect the power source (AC power
adaptor, rechargeable battery or alkaline
batteries). While you press and hold down
p ,
connect the power source again. To make the
beep sound again, disconnect the power
source, and then connect it without pressing
p .
Connecting to other
stereo equipment
You can listen to the CD through other stereo
equipment or record a CD on a cassette tape.
Refer to the instruction manual of the other
equipment for details. Before making
connections, turn off each piece of equipment.
Notes
• When you use a connecting cord, the Digital
MEGA BASS function will be disabled.
• Before you play the CD, turn down the volume
of the connected equipment so as not to
damage the connected speakers.
• The beep sound is not output from the LINE
OUT jack.
• When you connect other equipment to the
LINE OUT jack, you cannot adjust the volume
by this unit.
• When you record a CD on a cassette tape using
a tape recorder that has the blank search
function, release the ESP function. If the ESP
function is on, the blank search function does
not work.
z Power Sources
Using rechargeable
battery
Charge the rechargeable battery before using
it for the first time.
You can use either BP-DM10 or BP-DM20
rechargeable battery for this unit. You can use
them in the same way, but their charging time
and battery life are different. Check the model
number of your rechargeable battery, and use
it.
1
Open the lid of the battery compartment.
2
Insert the rechargeable battery so that the
word “SONY” is facing the same direction
as illustrated inside the lid, and close the
lid.
3
Connect the AC power adaptor.
The indication “CHG” lights up. Charge
for about 2 hours (for BP-DM10) or 3
hours (for BP-DM20).
(If the battery has been already charged,
“CHG“ and
flash. )
4
When fully charged, “CHG” disappears.
Disconnect the AC power adaptor.
When to charge the battery
When the battery becomes weak,
indication appears in the display. If the
battery is used up, “
Lo batt ” appears in the
display. Charge the rechargeable battery.
To keep the original battery capacity for a long
time, recharge the battery when the battery is
used up (discharged).
Notes
• Charging time varies depending on how the
rechargeable battery is used.
• If the battery is new or has not been used for a
long time, it may not be charged completely
until you charge and discharge it several times.
• If the battery life becomes shorter by about half,
replace it with Sony BP-DM10 or BP-DM20
rechargeable battery. Do not use any other
rechargeable battery (R6 type rechargeable
battery, etc.).
RESUME
ON OFF
Playing a CD in a car
You can use your Discman in a car as
illustrated below.
To connect your Discman to a car cassette
deck, you need the following accessories:
• Car connecting pack CPA-9
• Car battery cord DCC-E245
or,
• Mount kit CPM-300PC (Mount plate + Car
connecting pack + Car battery cord)
• Car battery cord with car connecting pack
DCC-E26CP
Refer to the instruction manual of each
accessory for details.
When you use the CPM-300PC mount
kit/CPM-300P mount plate
Attach the car mount adaptor supplied to the
CPM-300PC/300P before installing the
Discman.
Notes
• Do not put the Discman on the dashboard.
• Do not leave the Discman in a car parked in
sunlight.
• Use a Sony car connecting pack for reducing
noise.
Switched ignition function
With this feature, your Discman stops
automatically when you turn off the engine of
the car. (This function is not possible with
some cars depending on the model).
(rear)
DC IN 4.5 V
AC power adaptor
to a wall outlet
LINE IN or
REC IN
Stereo system,
cassette recorder,
radio cassette
recorder, etc.
Connecting cord
RK-G129HG
Left (white)
Right (red)
LINE OUT
Using dry batteries
1
Open the lid of the battery compartment.
2
Insert two LR6 (size AA) alkaline
batteries by matching the
‘ and ’ to the
diagram inside the battery compartment
and close the lid.
When to replace the dry batteries
When the battery becomes weak,
indication appears in the display. If the
batteries are used up, “
Lo batt ” appears in
the display.Replace all the batteries with new
ones.
Notes
• Do not charge the dry batteries.
• Do not mix new batteries with old ones.
• Do not use different types of batteries together.
• Do not use manganese batteries for this unit.
Battery life (approx. hours)
When using ESP function
off
on
BP-DM20 10 7
(charged for
about 3 hours*)
Two alkaline batteries 18 13
BP-DM10 5 3.5
(charged for
about 2 hours*)
(When the unit is used on a flat and stable place)
*Charging time varies depending on how the
rechargeable battery is used.
(rear)