Star Micronics LC-1021 - Manual (Page 59)

Troubleshooting guide 53
Printer does not feed paper
properly. Jamming paper. Remove all paper from the
printer and then reload it.
The printer is not set up
correctly for the thickness of
paper being used. Set up the printer for the
paper thickness you are
using. See “Adjusting for
paper thickness” on
page 42.
Line spacing is incorrect. Jamming paper. Set up the printer for the
paper thickness you are
using. See “Adjusting for
paper thickness” on
page 42.
The line spacing or leading
selected in your application
program is wrong. Choose a different line
spacing or leading setting
from your application.
Auto line feed with carriage
return is enabled. Use the EDS Mode to
disable auto line feed with
carriage return. See “Switch
4: Auto LF with CR” on
page 32.
Lines print over each other. Auto line feed with carriage
return is disabled. Use the EDS Mode to
enable auto line feed with
carriage return. See “Switch
4: Auto LF with CR” on
page 32.
Jamming paper. Set up the printer for the
paper thickness you are
using. See “Adjusting for
paper thickness” on
page 42.
Problem Possible Cause Recommended Action