Sony D-NE9 - Manual (Page 50)

50
Troubleshooting
Symptom
The CD does not play, or
“No disc” appears in the
display when a CD is
placed in the CD player.
CHARGE lamp flashes on
the CD player when you
press a button, and the
CD does not play.
Cannot adjust the volume
with VOL +/– on the CD
player.
The rechargeable
batteries cannot be
charged.
Playback starts from the
point you stopped.
(resume function)
Rustling noise is heard
from the CD.
When using with a
connected stereo system,
the sound is distorted or
noisy.
Cause and/or corrective actions
c The buttons are locked. Slide the HOLD switch back.
c The CD is dirty or defective.
c Check that the CD is inserted with the label side up.
c Moisture condensation has occurred. Leave the CD player aside for
several hours until the moisture evaporates.
c Close the lid of the battery compartment firmly.
c Make sure the batteries are inserted correctly.
c Connect the AC power adaptor to an AC outlet securely.
c Press the jog lever after one second or more has passed since the AC
power adaptor was connected.
c The CD-R/RW is blank.
c There is a problem with the quality of the CD-R/RW, recording device,
or application software.
c Files in two or more formats have been recorded on the same CD-R/
RW.
c The buttons are locked. Slide the HOLD switch back.
c The CD player is connected to an audio device. Adjust the volume using
the volume control on the connected device.
c The terminals on the charging stand are dirty. Wipe them with a dry soft
cloth, etc.
c The CD is playing. Stop play.
c The external battery case is connected to the CD player. Remove it and
start charging again.
c The CD player is not placed securely on the charging stand. Place the
player on the stand, aligning the V mark on the player and the v mark
on the stand. Make sure that the CHARGE lamp lights up.
c The resume function is working. To start playing from the first track,
hold down the jog lever during stop until the first track starts playing or
open the lid of the CD player. Or, remove all power sources, then insert
the batteries or connect the AC power adaptor again.
c Close the lid of the battery compartment firmly.
c Adjust the volume of the connected device.