Appendix: manual network configuration – Sony TTR1 User Manual
Page 71
71
Appendix: Manual Network Configuration
Connect to a Wired Network Using Manual Settings
In order to connect to a wired network, you will need to have the following
information to enter during the procedure:
Is DHCP enabled or disabled?
If disabled, the IP address to use for the Radio?
If disabled, the Subnet Mask IP address?
If disabled, the Gateway IP address?
If disabled, the Primary DNS IP address?
If disabled, the Secondary DNS IP address?
a.
At the rear of the Radio, remove the compartment cover and
connect an Ethernet cable to the Ethernet connector on the inside
left of the compartment . Refer to “Wired Ethernet Connector”
on page 11 for the location of the Ethernet connector . Replace the
compartment cover .
b.
Connect the other end of the Ethernet cable to your home’s wired
network .
c.
If you have just turned your SIRIUS|XM TTR1 Radio on for the first
time, the SSID screen will already be displayed . Skip ahead to step f .
d.
Press MENU and turn the TUNE knob to highlight System Setup .
Press the TUNE Knob .
e.
Turn the TUNE knob to highlight Network . Press the TUNE Knob .
f.
Turn the TUNE Knob to highlight Manual Settings [Manual config] .
Press the TUNE Knob .