Sony D-T405 - Manual (Page 35)

34
To protect your hearing (AVLS)
I
The AVLS (Automatic Volume Limiter
System) function keeps down the
maximum volume to protect your ears.
Set AVLS to LIMIT.
The AVLS indication appears.
To resume playing from the
point you stopped the CD
(Resume Play) J
Normally, every time you stop and
play, playing starts from the beginning
of the CD. The resume play function,
however, lets you listen to from the
point at which you last turned off the
Discman.
Set RESUME to ON.
To cancel resume play, set RESUME to
OFF.
To turn off the beep
You can turn off the beep that sounds
as you operate your Discman. (You
cannot turn off the beep that sounds
during the radio operation.)
Disconnect the power source (AC
power adaptor, rechargeable battery or
alkaline batteries). While you press
and hold down
p on the main unit,
connect the power source again.
To make the beep sound again,
disconnect the power source, and then
connect it without pressing
p.
Connecting to other stereo
equipment K
You can listen to the CD through other
stereo equipment, or record a CD on a
cassette tape or a MiniDisc. Refer to
the instruction manual of the other
equipment for details. Before making
connections, turn off each piece of
equipment.
When you connect the Discman to a
MiniDisc recorder, DAT deck, etc., use
the optical digital connecting cord.
When you connect the Discman to a
stereo system, cassette recorder, radio
cassette recorder, etc., use the
connecting cord.
Recording with optical digital
connection
Record a CD on a MiniDisc, DAT, etc.,
according to the following procedure.
1 Press
^ on the CD player to start play.
2 Press ^ again to pause.
3 Press =/+ to select the track you
want to record.
4 Press r (record) on the MiniDisc
recorder, DAT recorder, etc.
5 Press ^ on the CD player to release
pause.
Notes
• Connect the optical digital connecting
cord while the CD player is in stop
mode.
If you make connection just after
stopping the CD player, optical signals
may not be output.
• If you record without pausing the CD
player, some CD may have problem
with recording the first track number
correctly.
• When you use digital equipment with
this unit, use the AC power adaptor. If
you use a rechargeable battery or
alkaline batteries, the optical digital
signal will not be output from the unit.
(Un expected phenomena may occur,
for instance, you cannot record a CD on
connected equipment.)
• MEGA BASS system works on output
from the PHONES/REMOTE jack, but
does not work on optical digital output
from the OPTICAL (DIGITAL)/LINE
OUT jack.
• When you use an optical digital
connecting cord, the ESP function will
be disabled.