Speco Technologies SIPMPBVFH - Manual (Page 33)

2-29
2.3.4 IP Settings
Connection Type
Click the [Connection Type] item to display the “Connection Type Page”. Refer to the
table below for how to configure each setting.
Parameters Description
Dynamic IP
address
Click this to enable IP device’s DHCP function.
It will acquire its WAN port IP address from a DHCP server
within the same network. (You must have a DHCP server in
order to enable this function.)
Static IP
address
Click this to manually enter the IP address.
IP address: Enter the WAN port IP address.
Subnet mask: Enter the subnet mask of WAN port. If IP
address is changed, adjust the subnet mask
accordingly.
ISP gateway: Enter the IP address of the gateway (the
router).
PPPoE
Click this when you connect IP device directly to the xDSL
modem.
User name: Enter the user name of your xDSL account.
Password: Enter the password of your xDSL account.
Note: You have to click the [Save Reboot] after you click the
[Apply button] to let this IP device start xDSL connections.