Speco Technologies SIPMPBVFH - Manual (Page 46)

2-42
STEP2: Click the checkbox to enable motion detection for each individual region.
STEP3: Click one region to start to edit its size and location. You can click the “Adjust
Column” to drag motion region to your desired location. You can click the “Adjust
Square” and drag to adjust motion region size. You can click the upper right button to
cancel this motion region. Repeat above procedure to adjust the motion region.
STEP4: Set the sensitivity of motion detection region.
STEP5: Set the interval time of motion detection. After a motion event is triggered,
no more events will be triggered within this time in the same region
STEP6: Set the trigger threshold of motion detection region. The larger this value,
the larger the object size needed to trigger motion detection.
STEP7: In motion activity window, the bar shows the motion activity status. You
can also see the trigger threshold (Red line). When the motion activity exceeds the trigger
threshold, the bar would become red to indicate that a motion event has been triggered.
While viewing the motion activity window, you can adjust the motion sensitivity (the
higher, the easier camera considers video change to be an activity) and the threshold (the
higher, the larger the activity needed to trigger a motion event). If the default settings are
not satisfactory for your scene, you may try our alternative recommendations of:
Sensitivity: 80, Threshold: 2~5 (for normal environment)
Sensitivity: 80, Threshold: 5~10 (for very noisy environment)
PIR (Passive Infra Red motion sensors) (Not available to all models)
PIR sensors are available for some models. For the models with PIR, there will be a PIR
Motion Sensor section below the video motion detection.
You may enable PIR sensors by the checkbox and modify the sensitivity/ trigger
interval.
When motion is detected via PIR sensor, a red border will show around the whole view
area.
Please note that PIR sensors have a shorter range of detection than Video motion
detection.