Sony PCWA-C100 - Manual (Page 49)

49
Setting up the Access Point
You can change the Access Point settings by using the
Basic Setup Utility. Changes to the settings may be
made by using the Custom Setup Utility as well.
This operation must be performed on a single
computer on the wireless LAN.
1
From the Start menu, click VAIO - Wireless LAN -
Basic Access Point Setup Utility.
The Basic Setup Utility starts.
2
Confirm that the Access Point ID displayed is the
one assigned to the Access Point you are
configuring, then click SCAN.
The Access Point ID is a six-digit number on the
label attached on the bottom surface of the Access
Point. If the Access Point ID displayed is different
from the one on the label, enter the correct ID.
Note
If an error message
appears, click OK then
confirm the following and
repeat step 2.
• The Access Point is
powered.
• The correct Access
Point ID is displayed.
• The Access Point and
the computer are
located within a rage of
approximately 50 m
(165 feet).
z Tip
To launch the Custom
Setup Utility, click the
Start button and select
VAIO - Wireless LAN -
Custom Access Point
Setup Utility.
Access Point ID
Factory-set Encryption KEY