Sharp PG-D3510X - Manual (Page 55)

51
Useful
Featur
es
6 Fan Mode Setting
This function changes the fan rotation speed.
Selectable
items
Description
Normal Suitable for normal environments.
High Set when using the projector at
altitudes of approximately 1,500 meters
(4,900 feet) or more.
When “Fan Mode” is set to “High”, the fan rotation
speeds up, and the fan noise becomes louder.
7 System Lock Function
This function prevents unauthorized use of the
projector. Once this function is activated,
users must enter the correct keycode each
time the projector is turned on. We suggest
you record the keycode in a safe place
where only authorized users have access.
Info
If you lose or forget your keycode, contact
your nearest Sharp Authorized Projector
Dealer or Service Center (see page
67 ). Even
if the product warranty is valid, the keycode
reset will incur a charge.
•
a Setting/Changing the Keycode
1
Select “System Lock”, then press
ENTER or Q.
2
Select “Next”, then press
ENTER.
The screen for entering the keycode
appears.
3
Press the 4 buttons on the remote
control or on the projector to enter
the preset keycode in “Old Code”.
When setting the keycode for the fi rst time,
press R on the projector for four times.
Setting the System Lock
PRJ - ADJ1
Old Code
New Code
Reconfirm
– – – –
– – – –
– – – –
•
•
1
2
3
Menu operation n Page 40
If you input a wrong keycode, the cursor returns to
the fi rst point of the “Old Code”.
The preset keycode is 4 R buttons on the
projector. When you press the R button four
times, the keycord input screen disappears. •
•
Note
4
Press the 4 buttons on the remote
control or on the projector to enter
the new keycode in “New Code”.
You cannot use the following buttons
for keycode: STANDBY/ON, ON,
STANDBY, ENTER, L-CLICK, R-
CLICK/RETURN and MENU
System Lock function recognizes
each button on the remote control
or on the projector as an individual
button, even if they share the same
button name. If you used the buttons
on the projector in setting your
keycode, the keycode cannot be
canceled with the remote control. •
•
Note
Setting the System Lock
Old Code
New Code
Reconfirm
* * * *
– – – –
– – – –
PRJ - ADJ1
5 Enter the same keycode in “Re-
confi rm”.
To cancel the keycode that you have
already set
Press R on the projector for four times in
steps 4 and 5 above.
When the System Lock is set
When System Lock is set, the keycode input
screen appears after the power is turned on.
When it appears, enter the right keycode to
start projection.
Input screen for keycode
System Lock – – – –
•
•
Note
4
5