Removing and installing the lamp unit, Removing and installing the, Lamp unit – Sharp PG-D3510X User Manual

Page 65

Advertising
background image

61

Appendix

Removing and Installing the

Lamp Unit

Warning!

Do not remove the lamp unit from the
projector right after use. The lamp and parts
around the lamp will be very hot and may
cause burns or injury.

Info

Do not touch the glass surface of the lamp
unit or the inside of the projector.
To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the
steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.

1

Press

STANDBY/ON on the

projector or

STANDBY on the

remote control to put the
projector into Standby mode.

2

Disconnect the power cord.

Unplug the power cord from the AC
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).

3

Remove the lamp unit cover.

Close the lens shutter and turn the
projector over. Loosen the user service
screw (1) that secures the lamp unit
cover. Remove the lamp unit cover (2).

Lamp unit

AN-D350LP

Optional

accessory

Lamp unit

AN-D350LP

Optional

accessory

1

STANDBY/ON button

AC socket

STANDBY/ON button

AC socket

2

3

User service screw
(for lamp unit cover)

User service screw
(for lamp unit cover)

Advertising
This manual is related to the following products: