Sony MV-7101DS - Manual (Page 17)

17
Use of Headphones
Listening with the
headphones
Before listening
• The transmitter for the cordless headphones
is on the monitor. See the location of controls
for the monitor (page 8).
• To prevent your ears from being damaged,
first lower the volume.
1
Turn on the monitor and the player.
2
Set the power switch to ON on the right
housing of the headphone.
The headphones turn on and the POWER
indicator glows red.
3
Put on the headphones.
Be sure to put the right housing (R) on your
right ear and the left housing (L) on your
left ear.
4
Start playback on the monitor and the
player.
5
Turn the VOL control dial to adjust the
volume.
If the infrared sensors of the headphones
are covered by your hands when adjusting
the volume, the attenuate function will be
activated and volume cannot be adjusted.
To adjust the volume, move nearer toward
the transmitter of the monitor, or orient the
infrared emitters on the left housing
towards the transmitter of the monitor.
Sound is automatically attenuated
if noise increases
— Attenuate function
If the infrared rays are obstructed, or the
headphones are used outside their effective
range, noise will increase and sound will
become hard to hear. To avoid potential ear
damage as a result of noise, this function
attenuates any sound in the headphones.
Sound is automatically restored when you
move nearer to the transmitter or remove the
obstruction.
After listening
Take off the headphones, and then turn off the
power (Noise may occur if you turn off the
monitor before taking off the headphones).
Power (ON/OFF)
switch
POWER indicator
VOL control dial