Sharp UX-300 - Manual (Page 109)

<P=002>
Line error
Problem Check and remedy
LINE ERROR appears in
the display and/or a
transaction report is printed
out with COM. E- and a
number from 0 to 1, 2, 3, 4,
5, 6, or 7 in the NOTE
column.
••••
Try the transaction again. If the error persists,
check the following:
••••
Check the hookup. The cord from the TEL. LINE
jack to the wall jack should be no longer than six
feet.
••••
Make sure there are no modem devices sharing
the same telephone line.
••••
Check with the other party to make sure their fax
machine is functioning properly.
••••
Have your telephone line checked for line noise.
••••
Try connecting your fax to a different telephone
line.
••••
If the problem still occurs, your fax machine may
need service.
Dialing and transmission problems
Problem Check and remedy
No dial tone when you pick
up the handset or press the
SPEAKER key.
••••
Make sure the handset cord is connected to the
correct jack. See
Handset in Connections in
Chapter 1.
Dialing is not possible.
••••
Make sure the power cord is properly plugged
into a power outlet.
••••
Make sure that the telephone line is properly
connected to both the TEL. LINE jack and the
wall jack.
••••
Make sure that the fax is set to the correct
dialing mode for your telephone line. See Option
Setting 8 in Chapter 8.
11
.T
ro
ub
le
-
sh
oo
ti
ng
Problems and Solutions
107