Sharp UX-300 - Manual (Page 22)

<P=005>
11
Rotate the large gear toward you until the film is taut.
12
Close the print compartment cover (press down on both sides to
make sure it clicks into place), and then close the operation panel.
Click!
13
Load paper in the paper tray and then press the following keys to
initialize the film.
Note: Paper must be loaded before the film can be initialized. To load
paper, see the following section, Loading the Printing Paper.
Display shows:
INITIALIZE FILM
When to replace the imaging film
Replace the imaging film when the display shows:
FILM END
Use the following imaging film, which is available from your dealer or
retailer:
FUNCTION
6
START/MEMORY
Sharp UX-3CR Imaging Film
Loading the Imaging Film
20