Sony GV-D200 - Manual (Page 9)

9
Getting started
Step 2 Preparing the power supply
Using with a battery pack (not supplied)
Install the battery pack to use your VCR outdoors.
Your VCR operates only with the “InfoLITHIUM” battery pack (L series).
Installing the battery pack
Press and slide the battery pack in the direction of the arrow.
To remove the battery pack
While pressing BATT, slide the battery pack to the right.
After installing the battery pack
Do not carry your VCR by holding the battery pack. If you do so, the battery pack may
slide off and cause damage to your VCR.
Remaining battery time indicator
When you use an InfoLITHIUM battery pack, the remaining battery time is displayed
on the monitor screen. It may not be displayed properly, however, depending on the
conditions and circumstances of use. The message appears when the battery is dead.
After you set the POWER switch to ON, it takes about 1 minute for the correct
remaining battery time to be displayed.
Battery Pack
(not supplied)
BATT