Sony CDP-XB720 - Manual (Page 19)

19 EN
Notes on CDs
On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc.
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• Do not use any commercially available stabiliser and/or
disc protector. If you do, the disc and the player may be
damaged.
• After playing, store the disc in its case.
On placing CDs on the disc tray
• Make sure the disc is positioned securely on the tray’s
spindle. If not, it may damage the player or the disc.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the centre out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
Additional Information
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the output level with LINE OUT
LEVEL +/– on the remote.
/When you use the headphones, adjust the
volume with PHONE LEVEL (only for
CDP-XB920 and CDP-XB820).
The CD does not play.
/There’s no CD inside the player (“– NO DISC –”
appears). Insert a CD.
/There’s no stabiliser on the CD
(“– NO STABI –” appears). Place the stabiliser
on the CD (only for CDP-XB920 and
CDP-XB920E).
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 19).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
The recording level has changed.
/The recording level changes if you press the
LINE OUT LEVEL +/– buttons on the remote
during recording.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
The disc tray opens and closes automatically when you
turn on the player (CDP-XB820 only).
/The player does this if you pushed the disc tray
in while the power was off the last time you
used the player.
/The player does this if the disc tray slipped out
of position due to shock or vibration during
transport.