Sim2 Multimedia DIGITAL D60 - Manual (Page 18)

18 Using the projector
Using the projector
Preparations
1.
Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the
AC inlet on the rear of the projector and turn on the power
switch.
3. Plug the power cable into a wall socket and turn the wall
switch on.
Turning the projector on
Follow the steps below.
1.
Make sure the Power light is orange after power has been
applied and the main AC power switch is turned on.
2. Press and hold POWER ( ) on the remote control to turn
the projector on.
3. The fans will start operating, and a start-up image displays
on the screen for a few seconds while it warms up.
4. If you are prompted for a password, press the arrow keys to
enter a six digit password. See "Utilizing the password
function" on page 20 for details.
5. "Source Searching..." will be displayed on the screen
before the projector identifies the input signal. This
message will remain on the screen until a valid signal is
detected. See "Selecting an input source" on page 18 for
details.
6. If the horizontal frequency of the input signal exceeds the range of the projector, the
message "Out of Range" will be displayed on the screen. This message will remain on-
screen until you change the input signal to an appropriate source.
Selecting an input source
The projector can be connected to multiple equipment at the
same time. When the projector is first turned on, it will attempt to
reconnect with the input source which was in use when the
projector was last shut down.
To select the video source:
• Using the remote control
Press one of the Source buttons on the remote control. To switch
between HDMI 1 and HDMI 2, press HDMI again.
• Using the OSD menu
1. Press MENU and then press / until the System menu is
highlighted.
2. Press to highlight Input Source and press ENTER. The source
selection bar displays.
3. Press / repeatedly until your desired signal is selected
and press ENTER.
Once detected, the selected source information will display
on the screen for seconds. If there is multiple equipment
connected to the projector, you can go back to the source
selection bar again to search for other signals.
• If you want the projector to automatically search for the
signals, select On in the System > Auto Source Search menu.
The projector will not
respond to further
commands while it is
warming up.
HDMI 1
Video
S-Video
Component 1
Component 2
Language
Splash Screen
My Screen
Projector Position
Auto Off
Sleep Timer
Background Color
Menu Settings
Input Source
System
S-Video
English
SIM2
Auto Source Search
EXIT Back
Disable
Disable
Blue
On
Floor Front
ENTER
RGB HD
HDMI 2
NOTE: When
automatically
searching for an
valid input source,
the projector cycles
through the
available signals
following the
sequence from top
to bottom as the
source selection
bar shows.
Display Setup