Sim2 Multimedia DIGITAL D60 - Manual (Page 39)

39 Using the projector
Setup menu
Information menu
This menu shows you the current operating status of the projector.
Menu Settings
Menu Display Time (10 sec)
Sets the length of time the OSD will remain active after your last key
press. The range is from 5 to 30 seconds in 5-second increments.
Menu Position
(Center)
Sets the On-Screen Display (OSD) menu position.
Input Source
Selects an input source to be projected. See "Selecting an input
source" on page 18 for details.
Auto Source Search
(Off)
Sets whether the projector searches automatically for input
sources. If the source scan is Off, the projector will scan for input
sources until it acquires a signal. If the function is not activated, the
projector selects the last used input source.
FUNCTION
(default setting / value)
DESCRIPTION
Lamp settings
Lamp Power (Normal)
Selects the projector lamp between Normal and Whisper modes.
Lamp Hours
Shows the lamp hours information. See
"Getting to know the lamp
hour" on page 43 for details.
Pattern
Grid
Press ENTER to display the grid test pattern. It helps you adjust the
image size and focus and check that the projected image is free of
distortion.
Color Bar
Press ENTER to display the color bar test pattern. You can display this
test pattern to check that the colors are to your liking.
Dust Filter
Dust Filter Hours
Shows the dust filter hours information
Reset Dust Filter Timer
Resets the duster filter timer to '0'. See
"To clean the filter" on
page 42 for details.
High Altitude Mode
(Off)
A mode for operation in areas like high altitude or high
temperature. See
"Operating in a high altitude environment" on
page 31 for details.
Password
Password (Off)
Limits use of the projector to only those who know the correct
password. See
"Utilizing the password function" on page 20 for
details.
Change Password
You will be asked to enter the current password before changing to
a new one. See
"Utilizing the password function" on page 20 for
details.
Reset All Settings
Returns all settings to the factory preset values.
The following settings will still remain: the selected input source, the
position of lens shift, names of user modes, Keystone, Phase, Language,
Projector Position, Reset Dust Filter Timer, High Altitude Mode, and
Password.