Sim2 Multimedia DIGITAL D60 - Manual (Page 47)

47 Additional information
Troubleshooting
Problem Cause Remedy
The projector does
not turn on.
There is no power from the
power cable.
Plug the power cable into the AC inlet
on the rear of the projector, and plug
the power cable into to the power
outlet. If the power outlet has a
switch, make sure that it is switched
on.
(See page 18)
The power switch is not in the
on position. Put the power switch in the on
position.
(See page 18)
Attempting to turn the
projector on again during the
cooling process.
Wait until the cooling down process
has completed.
The lamp cover is not securely
attached.
Correctly attach the lamp cover. (See
page 44)
No picture.
The video source is not turned
on or connected correctly.
Turn the video source on and check
that the signal cable is connected
correctly. (See page 15)
The projector is not correctly
connected to the input source
device. Check the connection. (See page 15)
The input signal has not been
correctly selected.
Select the correct input signal with the
Source buttons on the remote control.
(See page 18)
Image is unstable.
The connection cables are not
securely connected to the
projector or the signal source.
Correctly connect the cables to the
appropriate terminals.
(See page 15)
Picture is blurred.
The projection lens is not
correctly focused.
Adjust the focus of the lens using the
focus ring. (See page 19)
The projector and the screen
are not aligned properly.
Adjust the projection angle and
direction as well as the height of this
unit if necessary.
(See page 22)
Remote control
does not work
correctly
The batteries are out of power. Replace both of the batteries with
new ones. (See page 5)
There is an obstacle between
the remote control and the
projector.
Remove the obstacle. (See page 5)
You are too far away from the
projector.
Stand within 8 meters (26.2 feet) of the
projector. (See page 5)