Sony WAHT-SA1 - Manual (Page 9)

9 US
3
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator
turns green. If not, see “Checking the
transmission status” (page 9).
4
Set up the speakers.
If the S-AIR main unit has the Auto
Calibration function, perform Auto
Calibration. If the S-AIR main unit
does not have the Auto Calibration
function, perform the appropriate
speaker setting. For details, refer to the
operating instructions of the S-AIR
main unit.
Checking the
transmission status
You can check the status of sound
transmission between the S-AIR main unit
and surround amplifier by checking the
POWER / ON LINE indicator on the
surround amplifier.
Enjoying the sound by
using headphones
You can enjoy the system’s sound in a place
away from the S-AIR main unit by
connecting the headphones to the PHONES
jack on the surround amplifier.
Note
• When you connect headphones to the surround
amplifier, neither the surround amplifier nor the
S-AIR main unit outputs sound from the
system’s speakers.
• The volume of the S-AIR main unit is minimized
if you turn off the surround amplifier with
headphones connected, or radio reception is
poor. In either case, check radio reception, and
set the volume again.
POWER / ON
LINE indicator Status
Turns green Sound transmission is
established.
Flashes green Sound transmission is not
established. For details, see
“Troubleshooting”
(page 12).
Turns red The surround amplifier
does not output sound. For
details, see
“Troubleshooting”
(page 12).
Turns off The surround amplifier
turns off or its protection is
active. For details, see
“Troubleshooting”
(page 12).