SMSC LAN9420 - Manual (Page 150)

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
Revision 1.22 (09-25-08) 150 SMSC LAN9420/LAN9420i
DATASHEET
Table 4.10 lists the standard PCI header registers that are supported. Registers whose initial values
for Subsystem Vendor ID and Subsystem Device ID, are configured from the EEPROM are indicated
by ‘YES’ in the “EPROM CONFIGURABLE” column.
Note 4.7 Default value is dependent on device revision.
Note 4.8 BAR3’s read back value is FFFFFC00h after writing FFFFFFFFh. BAR4’s read back value
is FFFFFF01h after writing FFFFFFFFh.
Note 4.9 The Subsystem Vendor ID and Subsystem Device ID can be configured by the serial
EEPROM. if no EEPROM is connected to LAN9420/LAN9420i, then the default values in
the table are used.
Table 4.10 Standard PCI Header Registers Supported
CONFIGURATION
SPACE OFFSET REGISTER NAME
READ/
WRITE DEFAULT
EEPROM
CONFIGURABLE
00h - 01h Vendor ID RO 1055h
02h - 03h Device ID RO E420h
04h - 05h Command R/W 00h
06h - 07h Status RO, R/WC 0410h
08h Revision ID RO Note 4.7
09h - 0Bh Class Code RO 020000h
0Ch Cache Line Size R/W 00h
0Dh Latency Timer R/W 00h
0Eh Header Type RO 00h
0F - 1Bh RESERVED RO
1Ch - 1Fh BAR 3 ( Note 4.8 )
(For NP-Mem mapped 1Kbyte)
R/W 00000000h
(FFFFFC00h)
20h - 23h BAR 4 ( Note 4.8 )
(For I/O mapped 256byte)
R/W 0000001h
(FFFFFF01h)
24h - 2Bh RESERVED RO
2Ch - 2Dh Subsystem Vendor ID (SSVID)
(
Note 4.9 )
RO 1055h YES
2EH - 2Fh Subsystem Device ID (SSID)
(
Note 4.9 )
RO 9420h YES
30h - 33h RESERVED RO
34h Capabilities Pointer RO 78h
35h - 3Bh RESERVED RO
3Ch Interrupt Line R/W 00h
3Dh Interrupt Pin RO 01h
3Eh Min_Gnt RO 02h
3Fh Max_Lat RO 04h