Sharp X2 - Manual (Page 29)

Operations 17
Menu options (con’t)
Set mode (con’t)
The following describes the attribute available for
each media:
Option Description Parameters
Wait Carriage The Wait Carriage attribute determines the
time delay in seconds that the printer waits
between passes to allow the ink to be
absorbed by the media. 0 – 30 seconds in 0.1 second
intervals.
Wait Cut The Wait Cut attribute determines the amount of
time, in seconds, the printer waits after the last
pass before performing the cut operation. This
allows time to let the print image stabilize to
avoid possible smearing before cutting the print
from roll. 0 – 30 seconds in .1 second
intervals
Magnification The vertical movement of media between
passes of the carriage head is governed by the
number of cycles of the media transport
system's forward motor. This fine-tunes the
amount of media vertical movement that is
associated with each pass of the print heads.
This value is set at the factory and may vary
slightly from media to media.
-0.50% -- and +0.50% in 0.01
intervals.
Note: Changing magnification is only
recommended to fine tune an image. A setting
change can affect other modes for different
images and different media types. True size
proportions can be compromised.
Cut Mode Sets automatic media cutting. NORMAL CUT / NO CUT