Sharp X2 - Manual (Page 45)

Supplies 33
Loading and removing media (con’t)
Loading media in the printer (con’t)
3. Turn the locking knob on the media end cap to its locked
position to secure it in the media roll.
4. Repeat steps 2 and 3 for the opposite end of the media roll.
5. Open the printer’s top cover.
6. Set the new media roll on the printer.
7. Media width guides are provided on the printer’s media roll
feeder.
Set position Media Size
First position 54 inches (1372 mm)
Second position 50 inches (1270 mm)
Third position 42 inches (1067 mm)
Fourth position 36 inches (914 mm)
Fifth position 23.4 inches (594 mm) / 11" (279 mm)
8. Set the right end cap at the position matching the media
width. The front guides are freely–rotating support rollers.
9. Rotate the media end cap to unroll 3 to 4 inches of media
from the roll.
10. Insert the leading edge into the feeder’s media input.
Caution - Media rolls, particularly the larger widths, are
heavy and awkward to handle. Ask for assistance when
installing these media rolls to avoid personal injury, damage
to the printer or damage to the media.