Sharp FO-2970M - Manual (Page 28)

Setting Up the Multifunction Interface
26
Installing the Multifunction software
Minimum system requirements
Processor: Pentium 90 MHz or higher
Operating system:
Windows

95/98, Windows NT

4.0
(Service Pack 3 or later), English version
Physical RAM: Windows 95/98: 16 MB
Windows NT 4.0: 32 MB
Free hard-disk space: Windows 95/98: 30 MB
Windows NT 4.0: 35MB
♦ The Sharp Laser Multifunction software cannot be installed by Plug
and Play. If the New Hardware Found box appears when you turn
on your computer, click the Cancel button to exit the dialog box.
♦ If you have other multifunction device software installed in your
computer, uninstall that software before installing the Sharp Laser
Multifunction software. Otherwise, the Sharp Laser Multifunction
software may not function correctly.
1. Insert the Sharp Laser Multifunction CD into your computer’s CD-
ROM drive.
2. If the Sharp Laser Multifunction Setup window appears, click Next
in the window and go to step 4. If the window doesn’t appear, click
the Start button on the Windows taskbar and select the Run...
command.
3. Type e:\setup in the Open text box, where e is the letter of your CD-
ROM drive, and then click OK.
4. Follow the instructions that appear on the screen.
5. When installation is completed, restart your computer.
all-fo2970.book Page 26 Monday, July 24, 2000 7:45 AM