Sharp FO-2970M - Manual (Page 57)

Sending a Fax by Automatic Dialing
55
2. Sendi
ng
Doc
u
ments
9
Return to Step 3 to store another
number, or press the STOP key to
return to the date and time display.
Chain Dialing for area and access codes
You can also program an area code or access code in a Rapid Key or
Speed Dial number using the above programming procedure. In Step
8, press 1 to set the number as a Chain Dialing number.
After you dial an area code or access code using a Rapid Key or Speed
Dial number set for Chain Dialing, the fax machine will wait for you
to dial the remainder of the number (you can dial the remainder of the
number by pressing a Rapid Key, by pressing the Speed Dial key and
entering a Speed Dial number, or by pressing numeric keys). Note that
the remainder of the number should not be set as a Chain Dial number
if programmed in a Rapid Key or Speed Dial number.
♦ The maximum number of digits that can be dialed at one time by
Chain Dialing is 50.
Clearing auto-dial numbers
1
Press these keys:
The display will show:
FAX/TEL # MODE
1=SET,2=CLEAR
8
Press 1 if the number programmed is
an area code or access code to be used
for Chain Dialing (see Chain Dialing
for area and access codes below).
Press 2 (or START) if the number is a
regular fax or voice number.
Step 3 or
or
ON OFF
1 2
STOP
3
FUNCTION
all-fo2970.book Page 55 Monday, July 24, 2000 7:45 AM