SRS Labs Plasma Display Panel Television - Manual (Page 26)

English - 26
continued...
Basic Functions
6. Program Information
EPG-Electronic Program Guide
The electronic program guide gives you a programme list for the channels.
➢
1. This service depends on service provider.
2. After receiver recognized the GMT - time from the signal which takes
few seconds, it can display correct EPG information.
• Press the GUIDE button while you are viewing a program.
This function is displayed on the screen by using only time.
• RED button: Red button is for moving back to the previous date.
• GREEN button: Green button is for moving to the next coming date.
• INFO button: This button is used to watch the program information, if there
is more information than one page. Use the … or † buttons to move up
and down pages.
• œ or √ button: Use to display the program list by 30 minutes per block.
Time interval can be adjusted by pressing buttons as followings on EPG
screen:
1 button: 1 hour and 30 minutes
2 button: 30 minutes
3 button: 15 minutes
• Select the channel by pressing the … or † buttons and press the
ENTER/OK ( ) button to watch this channel.
Operating the DTV Menu
Main Menu
After installing your antenna system and TV with appropriate connectors.
• Plug in the AC main power and switch on the TV.
• Press the D.MENU button to bring up the main menu.
The following on-screen display will appear:
The sub menu topics will be displayed. For the sub-menus Installation,
Channel Organising
and Parental Lock, you need the PIN Code.
1. Installation
This menu consists of 4 sub-menus:
Select Country, Auto Scanning, Manual Scanning and Reset to Factory
Defaults.
• Select Installation by pressing the ENTER/OK ( ) button in the
main menu mode to select the sub menu.
• Enter the PIN Code.
➢
If you have not entered your own PIN Code then the PIN Code 0000
applies, which was set at the factory.
➢
Once you have entered PIN Code, you do not have to input the code
again unless you turn the TV power off.
Installation
Channel Organising
Parental Lock
System Setup
Installation >
Installation
Channel Organising
Parental Lock
System Setup
Select Country
Auto Scanning
Manual Scanning
Reset to Factory Defaults
Installation > Select Country
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 26