KTM ENDURO 640 LC4 - Manual (Page 15)

ENGLISH
14
DRIVING INSTRUCTIONS
»
Check the following before each start
When you start, the motorcycle must be in perfect mechanical condition. For
safety reasons, you should make a habit of performing an overall check of
your motorcycle before each start.
The following checks should be performed:
1 CHECK OIL LEVEL
Insufficient oil results in premature wear and consequently to engine
damage.
2 FUEL
Check that there is sufficient fuel in the tank.
3 CHAIN
A loose chain can fall from the chain wheels; an extremely worn chain can
tear, and insufficient lubrication can result in unnecessary wear of chain
and chain wheels.
4 TIRES
Check for damaged tires. Tires showing cuts or dents must be replaced.
The tread depth must comply with the legal regulations. Also check the
air pressure. Insufficient tread and incorrect air pressure deteriorate the
driving performance.
5 BRAKES
Check correct functioning of the braking system. Check for sufficient
brake fluid in the reservoir. The reservoirs have been designed in such a
way that brake fluid does not need to be refilled even when the brake pads
are worn. If the level of brake fluid falls below the minimum value, this
indicates a leak in the braking system or completely worn out brake pads.
Arrange for the braking system to be checked by a KTM specialist, as com-
plete failure of the braking system can be avoided.
Also check the state of the brake hose and the thickness of the brake lin-
ings.
Check free travel at hand brake lever and foot brake lever.
6 CABLES
Check correct setting and smooth operation of all control cables.
7 COOLING FLUID
Check the level of cooling fluid when the engine is cold.
8 ELECTRICAL SYSTEM
Check correct operation of headlamps, tail-lights, brake lights, indicators,
control lamps and horn while the engine is running.
9 LUGGAGE
If you are taking luggage with you, check that this is securely fastened.
10 REAR MIRROR
Sit on the motorcycle and check the adjustment of the rear mirror.
1
Starting when the engine is cold
1 Open the fuel tap [1]
2 Switch on ignition (turn ignition key [2] into position ).
3 Switch on emergency OFF switch [3].
4 Switch transmission to idle (green indicator lamp N [4] lights up).
5 Operate cold starting device (choke) [5].
6 Do not accelerate; operate starter button [6].
7 If the engine starts, push the choke lever back a little bit, as soon as the
engine runs unevenly.
8 Take the motorcycle off of the main stand or side stand.
– TO AVOID INJURIES, IT IS RECOMMENDED TO WEAR BOOTS WHEN USING THE
KICKSTARTER.