Konica Minolta BIZHUB C30P - Manual (Page 27)

Selecting Driver Options/Defaults (for Windows) 13
Selecting Driver Options/Defaults
(for Windows)
Before you start working with your printer, you are advised to verify/change
the default driver settings. Also, in case you have options installed, you
should “declare” the options in the driver.
Windows XP/Server 2003/2000/NT 4.0
1
Choose the driver’s properties as follows:
– (Windows XP/Server 2003)
From the Start menu, choose Printers and Faxes to display the
Printers and Faxes directory. Right-click the KONICA MINOLTA
bizhub C30P PCL6 or KONICA MINOLTA bizhub C30P PS printer
icon and choose Properties.
– (Windows 2000/NT 4.0)
From the Start menu, choose Settings and then Printers to display
the Printers directory. Right-click the KONICA MINOLTA bizhub C30P
PCL6 or KONICA MINOLTA bizhub C30P PS printer icon and choose
Properties.
– PostScript printer driver for Windows NT 4.0 is not supported.
2
If you have installed options, proceed with the next step. Otherwise, skip
to step 9.
3
Select the Configure tab.
4
Check that the installed options are correctly listed. If not, proceed with
the next step. Otherwise, continue with step 8.
5
Click the Refresh to automatically configure installed options.
"
The Refresh is available only if bi-directional communication is
available with the printer; otherwise it is grayed out.
6
From the Device Options list, select an option, one at a time, and then
select Enable or Disable from the Settings menu.
"
If Printer Memory is selected, select 256 MB, 512 MB, 768 MB or
1024 MB, according to the installed memory. The factory default
setting is 256 MB.
"
If Memory Card is selected, select Disable, Enable (1 GB
Under), or Enable (1 GB Over), according to the installed Com-
pactFlash card.