Troubleshooting – KTM 990 SUPER DUKE User Manual
Page 76
TROUBLESHOOTING
»
75
TROUBLE
CAUSE
REMEDY
The battery is discharged
The ignition (power consumer) has-
n’t been switched off
The battery isn’t charged by the
generator
Recharge the battery according to the relevant instructions.
Voltage regulator and generator should be checked by an
authorized KTM workshop.
No values are visible in the
multi-functional digital
speedometer display.
Blown fuse
Replace fuse HORN BRAKELIGHT SPEEDO.
The speed indication on the
multifunctional digital
speedometer is not working
Pickup cable is damaged or con-
tacts on the cable connector have
oxidized
Check the pickup cable for damage, visit an authorized KTM
workshop
The blink code indicates which component is affected by an error. This allows the error to be identified if no diagnosis tool is available.
BLINK CODE
SIGNAL / COMPONENT
ERROR DESCRIPTION
ENGINE
02
Pulse generator
Malfunction
Stalls
06
Throttle sensor
Output signal too low /high
Continues to run
07
Sensor for 2nd throttle valve
Output signal too low /high
Continues to run
09
Intake manifold air pressure for sensor rear cylinder
Output signal too low /high
Continues to run
11
Intake manifold air pressure sensor for front cylinder
Output signal too low /high
Continues to run