Kowa KE811CT - Manual (Page 12)

FG
The screw for frame ground.
AUDIO IN 1-4
RCA connector for audio input connector.
These connectors are audio input connector.
These connectors are corresponding to INPUT 1-4 at front panel.
Please use a cable under 3m(9.84feet) in length when connecting.
AUDIO IN 5-8
Mini-jack for audio input.
These connectors are for audio input.
AUDIO IN 8 is located of front panel .
These connectors are corresponding to INPUT 5-8.
Please use a cable under 3m(9.84feet) in length when connecting.
AUDIO SUB OUT
RCA connector , audio output for SUB OUT.
These connectors are for audio output.
The audio output into AUDIO IN can be transmitted to SUB .
Please use a cable under 3m(9.84feet) in length when connecting.
SERIAL 1
DB9 connector for serial communication.
Serial communication is available.
Through this connector, the product can be controlled.
Straight cable is needed when this product is connected Personal Computer.
(Please refer to "5-2 Connection of RS232C cable.")
SERIAL 2
DB9 connector for serial communication.
Commands, which were beforehand registered, can be transmitted.
(Please refer to "5-2 Connection of RS232C cable.")
PARALLEL REMOTE
Ribbon connector, 50pin.
This product can be controlled by contact input.
Input-pin is non-voltage contact.
Output-pin is open-collector.
DC16V_IN
Connecter for power input.
DC16V AC adapter is connected.
Warning
The enclosed AC adapter must be used for this product.