Kowa KE811CT - Manual (Page 9)

KE811CT
2 The name and function of each parts
2-1. Front panel
POWER CONT button
This button controls external power. When this button is pushed,the signal (photo MOS relay
make contact)is output from connector for POWER CONT. (This button is not for the product.)
This button can be synchronized DISPLAY POWER button.
At synchronization mode, DISPLAY POWER buttons of CAT5 OUT, SUB OUT are ON when
POWER CONT button is ON.
(Please refer to "4-2. The setting of bottom dip switch.")
DISPLAY POWER button
This button control the power of equipments connected to CAT5 OUT and SUB OUT
(SERIAL 2) of rear panel. (Beforehand serial command should be registered.)
CAT5 OUT and SUB OUT(SERIAL 2) can be controlled independently.
Command is transmitted to SUB OUT(SERIAL 2) when DISPLAY POWER button is pressed
after pressing SUB OUT button.
Command is transmitted to CAT5 OUT when DISPLAY POWER button is pressed after
pressing CAT5 OUT button.
OPTION button
When this button is pushed, the signal (photo MOS relay make contact)is output from
connectors for OPTION A-F .Output can be selected momentarily or alternately.
The equipments connected to CAT5 OUT and SUB OUT(SERIAL 2) of rear panel can be
controlled in command. (Please refer to "4-2. The setting of bottom dip switch.")
Command is submitted to both of CAT5 OUT and SUB OUT(SERIAL 2).
INPUT button
Video and audio which are transmitted to CAT5 OUTor SUB OUTcan be selected.
button 1-3 are for composite video, button 4 is for component video, button 5-8 are for
RGB video.
CAT5 OUT and SUB OUT can transmit a video, a audio, and a command separately.
Video, audio and command are transmitted to SUB OUT when INPUT 1-8 buttons are pressed
after pressing SUB OUT button.
Video, audio and command are transmitted to CAT5 OUT when INPUT 1-8 buttons are pressed
after pressing CAT5 OUT button.
OFF button
Output of video and audio become OFF. Press again to release or press INPUT button to
release.
SUB_OUT button
SUB output is selected.