Kowa KE811CT - Manual (Page 20)

4-3. Operation of buttons
a) POWER CONT button
It can control the power in the rack. The operation of others buttons can be controlled
(become ON), when this button is pressed.
When NO.7 of bottom dip switch is ON, DISPLAY POWER button synchronizes and becomes ON.
(Please refer to "4-2. The setting of bottom dip switch.")
When POWER CONT button is OFF, all buttons are OFF (It is not related to a setup of a switch).
This button is not for this product, this product is ON when AC adapter is connected.
b) DISPLAY POWER button (command transmission button)
According to ON/OFF , command to notice power ON/OFF is transmitted to CAT5 or SUB(SELIAL 2)
and the connected equipments can be ON/OFF.
(ON/OFF serial command for the connected equipments shall be registered beforehand.)
The command to notice the other information can be transmitted to CAT5, SUB(SERIAL 2)
by registration.
The command is transmitted to SUB (SERIAL 2), when DISPLAY POWER button is pressed
after pressing SUB OUT button.
The command is transmitted to CAT5, when DISPLAY POWER buttons is pressed after
pressing CAT5 OUT button.
c) OPTION button (command transmission button)
It can control the curtain or screen etc... with relay of rear panel.
The setting alternate/momentary is available with bottom dip switch.
(Please refer to "4-2. The setting of bottom dip switch.")
The command can be transmitted to both of CAT5 and SUB (SERIAL 2).
If the command would not be transmitted to CAT5, do not register any command in CAT5.
If the command would not be transmitted to both of CAT5 and SUB (SERIAL 2), do not register
any command in CAT5 and SUB (SERIAL 2).
If the command would not be transmitted to SUB,do not register any command in SUB.
d) INPUT 1-8
One line from IN1-3 (composite), IN4 (component), IN5-8 (RGB), can be transmitted to CAT5
and SUB separately.
Command (which shall be registered beforehand) can be transmitted to CAT5 or SUB (SERIAL 2),
when the button is pressed.
The video, audio and command are transmitted to SUB, when one of INPUT 1-8 after pressing
SUB OUT button.
The video, audio and command are transmitted to CAT5, when one of INPUT 1-8 after pressing
CAT5 OUT button.
e) OFF button
Stopping transmission of video and audio.
To stop CAT5 output, press OFF button (is illuminated) after pressing CAT5 OUT button.
To release, press again (button is not illuminated) or press INPUT button.
f) CAT5 OUT button
Press this button to select CAT5 output (button is illuminated.).
g) SUB OUT button
Press this button to select SUB output (button is illuminated.).