KORG AX10A - Manual (Page 11)

12
Expression pedal
Selecting the effect that will be controlled by the
pedal
Press the PEDAL FX button to select the effect that
will be controlled by the pedal. The LED located at
the left indicates the effect (or volume) that will be
controlled.
ORG: NOTCH (orange): Notch filter frequency
RED : CHO (red): Chorus effect
GRN :ÎÖB (green): Effect selected by AMBIENCE
OFF : VOLUME (not lit): Volume pedal
Using the pedal to switch the effect on/off
By advancing the pedal all the way forward you can
switch the effect assigned to PEDAL FX on/off. When
on, the LED at the left of the pedal will light. If you’ve
assigned PEDAL FX to VOLUME or NOTCH, the
LED cannot be turned off.
Setting the minimum value of the volume pedal
If PEDAL FX is assigned to VOLUME, you can hold
down the FUNCTION switch and use the MIC &
BODY DEPTH buttons to set the minimum volume
that will be controlled by the pedal (VOL PEDAL
MIN).
Saving the sound of a specific pedal position
If the PEDAL FX is assigned to AMB, CHO, or
VOLUME, there is no way for you to save the sound
produced by operating the pedal. The effect will
always sound according to the current position of the
pedal. However if PEDAL FX is assigned to NOTCH,
you can save the notch filter frequency point speci-
fied by operating the pedal.
NR (Noise Reduction)
To adjust the amount of noise reduction, hold down
the FUNCTION button and turn the tone control
LEVEL (NR) knob.
Depending on the connected device, excessively
high NR settings may cause notes to be cut off. If
this happens, lower the level.
Storing a program
When you have created a sound you want to keep,
you can write (store) it into one of the 40 user
programs (0.1–9.4).
If you switch programs or turn off the power before
writing your edited program, the changes you made
will be lost.
The program that had been in the writing destina-
tion will be overwritten.
1. Press the WRITE button. The program number
will blink in the display, and the AX10A will be in
“write-ready” mode.
2. Use the program select switches to select where
you would like to store the program.
You cannot write to a preset program (01–94).
3. Press the WRITE button to write the program into
the selected program number.
If you decide not to write, press either of the
MASTER (CANCEL) buttons to exit write-ready
mode (display blinking). You will return to normal
operation.
2
3
1, 3
TYPE Explanation Normal PEDAL FX:CHO
CHORUS PEDAL CHORUS
CHORUS Stereo chorus for electric-acoustic. Effect depth:
0…30 Effect depth Does nothing